Enviro CE2005 Manuale Utente

PELLET STOVEEF THERMO 28PLEASE READ THIS ENTIRE MANUAL BEFORE INSTALLATION AND USE OF THIS PELLET-BURNING ROOM HEATER. FAILURE TO FOLLOW THESE INS

10DOOR GLASSDo not attempt to open the door and clean the glass while the unit is in operation or if glass is hot. To clean the glass, use a soft cott

11Routine Cleaning and MaintenanceHEAT EXCHANGER AND INTERNAL EXHAUST TUBES: ONLY TO BE CLEANED WHEN THE UNIT IS COLD. Clean away any fly ash that m

*NOTE: All troubleshooting procedures should be carried out by qualified technicians or installers.DO NOT:• Hold the ON / OFF BUTTON; this

Troubleshooting5. The stove will not shut off.«If the unit will not shut off, ensure that the thermostat (if equipped) is turned down below the room t

14WarrantySherwood Industries Ltd. gives a five year limited warranty on all steel manufactured parts. A one-year warranty is provided on all electri

The following information must be recorded by the installer for warranty purposes and future reference.NAME OF OWNER:_________________________________

2Introduction...3Important Safety Data...

3IntroductionIMPORTANT SAFETY DATA:Please read this entire manual before installation and use of this pellet fuel burning room heater. Failure to fol

4PELLET QUALITY:PELLET QUALITY IS IMPORTANT, PLEASE READ THE FOLLOWING PAGE.Your pellet stove has been designed to burn wood pellets only. Since ther

5WARNINGS AND RECOMMENDATIONS:A. Do not abuse the glass by striking or slamming the door shut.B. Do not attempt to operate the stove with broken gla

6IntroductionRATING LABEL LOCATION:The rating label is located on the hopper lid.APPLIANCE DIMENSIONS:373/8"(94.9cm)257/16"(64.6cm)251/4&quo

TURNING PELLET STOVE ON:Ensure the hopper has sufficient pellet fuel to start the unit.1. Set water temperature, using the rotary dial located above

8This is used to regulate the airflow through the pellet stove.• On the low heat output settings, push the slider all the way in.• On the hig

9Routine Cleaning and MaintenanceThe following list of components should be inspected and maintained routinely to ensure that the applia